It's not obvious that the bit is moving slightly on more than one axis, 'til the part (a pump impeller, according to one comment) turns sideways and you see those oval holes.
Man alive--if we had one of these in the office, there wouldn't be a single right angle or flat surface in this place.
via paulasworld on youtube
erm, the bit wouldn't need to move on more than one axis to make oval holes, the table just needs to tilt very slightly (so slightly the video would make it hard to pick up, especially given the viewing angle)
!Report as spam
Share your thoughts
Join over 240,000 designers who stay up-to-date with the Core77 newsletter.
Subscribe
Test it out; it only takes a single click to unsubscribe
Comments