Core77 Discussion Groups
  Materials & Processes
  Laser Cutting

Post New Topic  Post A Reply
profile | register | preferences | faq | search

UBBFriend: Email This Page to Someone! next newest topic | next oldest topic
Author Topic:   Laser Cutting
Gretels
unregistered 		posted 12-10-2003 06:04 PM              Reply w/Quote

I have just purchased a Universal X-660 and I am not sure I need the Coaxial air assist w/ optics protection and the cutting table...Any thoughts one way or the other?

IP: Logged

All times are ET (US)

next newest topic | next oldest topic

Administrative Options: Close Topic | Archive/Move | Delete Topic
Post New Topic  Post A Reply
Hop to:

Contact Us | www.core77.com

Copyright Core77, Inc. 2003

Powered by Infopop www.infopop.com © 2000
Ultimate Bulletin Board 5.45c

Notice: Core77 does promote a FREE exchange of design related ideas in these discussion boards, but will NOT permit unprofessional or spiteful posts. If you engage in inflammatory or immature use of this service, then we will be forced to delete your messages.