Posted by: hipstomp
|
Comments (1)
It's not obvious that the bit is moving slightly on more than one axis, 'til the part (a pump impeller, according to one comment) turns sideways and you see those oval holes.
Man alive--if we had one of these in the office, there wouldn't be a single right angle or flat surface in this place.
Designers' Open 2008
DESIGN PHILADELPHIA 2008
LONDON DESIGN FESTIVAL 2008
FREEDESIGNDOM 2008
ManufRactured EXHIBITION
London Design Festival 2008
Core77 visits NASA:
DesignPhiladelphia 2008
UGLY:
Comments
erm, the bit wouldn't need to move on more than one axis to make oval holes, the table just needs to tilt very slightly (so slightly the video would make it hard to pick up, especially given the viewing angle)